CALL US: 1-800-445-0624
Showing: 81-89 of 89    ««
Articles
 
document Where to use the PIC16F876 EPROM
The MICRO CHIP PIC16F876 is used in the following series of tanning systems: 1. SUN014 and SUN015 power boards used in SUNDASH, and PL69 series tanning systems.  PIC16F876 is reprogrammable and it should be reused and not discarded.
rating 17 Dec, 2012 Comments: 0
document Which parameters do I need to set when using the internal Third Party Interface feature?
When using the Third Party Interface (P26) feature on the Intellitan Plus timer,you must set the following parameters:P3 - Post session cooling delay. The factory default is one minute, this parameter can be set as high as five minutes. Depending on the size of the room in which the unit is...
rating 11 Dec, 2012 Comments: 0
document Why can`t I make my tanning unit run for thirty minutes with the Intellitan timer?
JK Products and Services., only manufactures timing systems for its tanning units that operate for a maximum of 8,10, 12, 15, or 20 minutes. Within these time limits our tanning units provide the maximum level of UV-output allowed by the Food and Drug Administration, under 21CFR, (4MED). The...
rating 10 Dec, 2012 Comments: 0
document Why has the body fan for my 232G (or other) stopped working?
If the body blower fan on your SUN|DASH tanning unit is not operating, first try plugging the body fan into a standard 110 Volt outlet. If the fan fails to work in a standard outlet, replace the body fan. If the fan works plugged in to another outlet, then check the receptacle on the back of...
rating 11 Dec, 2012 Comments: 0
document Why is my tanning unit turning off before the end of session?
First, disconnect any external controllers and run bed manually.There are several reasons why a tanning unit can turn off before the end of the session. Please have a detailed description of when the unit is turning off, what shows on the display of the timer when it shuts off, what you have to...
rating 11 Dec, 2012 Comments: 0
document Why is my timer display flashing 7777?
If your timer display is flashing 7777, the maximum time of the tanning system has been exceeded. The bed will turn off after its max time has expired and display `7777`. The Intellitan Plus timers will display `7777` when connected to a third party controller and the operator is trying to...
rating 10 Dec, 2012 Comments: 0
document Why is my timer display locked on Help?
If your timer display is locked on Help, the powerboard on your tanning unit is corrupt. We may be able to repair the powerboard for you. If we cannot, the powerboard will have to be replaced with a new one.For technical support call 1-800-643-0086, option 4.**You may contact a parts sales...
rating 11 Dec, 2012 Comments: 0
document Why is my timer display stuck on L33?
First, remove power from the unit by flipping the breaker off. Wait 30 seconds, then flip the breaker back on. If this does not solve the problem, replace your powerboard.
rating 11 Dec, 2012 Comments: 0
document wireless interface modules AP900 Retail
Tanning systems with the exception of the PL69 series (Ergloine Ambition, Soltron Kiss and Flirt), and CompuSun and T-Max® bed controllers require the use of the AP900 Retail Wireless module.  The AP900 is accompanied by an external power supply and will require a 120V power supply...
rating 17 Dec, 2012 Comments: 0

Showing: 81-89 of 89    ««